Home > Industry News > High Speed Door Control System

High Speed Door Control System

2019-05-24

High Speed Door Control System

Installation control system

(1) When the control system is installed, it must be in a power-off state and no current is passed.
(2) The control system checks the appearance and internal electronic components for damage during transportation before installation, otherwise it may cause serious harm to the user during debugging or use.
(3) Non-professionals, do not touch the electronic components on the control panel, especially the processor chip, otherwise the static electricity of the human body will cause permanent damage to the electronic components on the circuit board.

(4) Do not allow metal objects such as wire scraps, small screws, drill slag, etc. that are generated during the construction process to enter the control box, otherwise the circuit may be short-circuited.

high speed door

(5) During the process of installing the control box, do not perform any drilling, cutting, grinding and other mechanical processing on the control box.
(6) The unused wiring port must be sealed to ensure that the protection level of the control system is IP54.
(7) The wire tube should not be exposed or loaded and stretched.
(8) The control box cannot be embedded in the wall or installed close to the wall, otherwise it will affect the heat dissipation of the system.
(9) Confirm that the link points of all motor cables are correct and strong, otherwise the inverter may be damaged.

Previous: High Speed Door Airbag Sensor Test

Next: What sets high-speed doors apart?