High Speed Door Servo Control System

Introduction

Thank you for choosing High Speed Door Servo Control System.

Please read this manual carefully before you start to use the system. In this manual you will find instructions for how to set the operating code the control unit, malfunction diagnostics and debugging, and routine maintenance.

Notice:

Ø Before connecting the system to live wire place make sure the power supply is off.

Ø Please make sure the power voltage in the main circuit is the some as controller`s rated voltage. Also please make sure the ground terminal is properly and reliably connect to the ground wire.

Ø DO NOT touch output terminal directly. DO NOT shot circuit the output terminal and out shell.

Ø After the power supply is cut, and before the LCD is off, there still high voltage electricity in the circuit, so DO NOT touch the internal wiring and electronic components.

Ø Internal wiring and electronic components are very sensitivity to static electricity, so DO NOT let any object contact the internal wiring and electronic components of motor driver and the main circuit of the touch control panel.

Inspection

All product has passed inspection and testing before is leaving the factory.

When you open the unit place make sure there is no damager during shipping. Also to confirm the equipment ratings are matching your requirement.

General Characteristic

Our servo control system is suitable for high speed PVC and aluminum doors.

l

The system is in compact package, with high torque and high operating speed, lower noise, high reliability, smooth and soft operating curves, it`s suitable for high speed and intensive usage environment.

The rolling curtain can be controlled by wall switch, push button, bluetooth, radar, safety edge, photo eye, induction loops, etc.

Operating Speed: 0.5m/s-1.5m/s; Operating Width: ＜16㎡/30㎡/60㎡; Daily operating time: 2000 time; Rated voltage: 220V; Rated Output: 0.75 KW/1.5KW/2.2KW

Specification

Specification for Electronic Control System

Specification for Motor

Operating Instructions

1. Basic Function

The system can operated via: 1) control box; 2) inching electronic control; 3) continuous automatic operation; 4) emergency stop; 5) single side operation box; 6) time delay; 7) radar and/or induction loops. Please refer to wiring terminal for eternal connections.

System has fuse/safety wire shutdown switch for three-phase power protection, fuse/safety wire for operating circuit protection, and temperature sensing relay for motor protection.

2. Control Key/Button

a) [↑"Key/Button: Inching control door`s opening movement or continuous automatic opening.

b) [↓"Key/Button: Inching control door`s closing movement or continuous automatic closing.

NOTE: these setting are set according to the contact; however they can be changed according to operating needs.

c) [STOP" Key/Button: Push this key under emergency situation it will shutdown the operation and the door will stop and stay at that position

d)Four key on LCD are main menu key.

3. Install the Stroke Controller

Stroke Controller utilizes absolute encoder. Connect the absolute encoder and reducer via encoder`s axle, and fix the wings on to the reducer, than insert the aviation plug into plug receptacle.

4. Safety

1) The motor and control unit MUST ground properly;

2) During the installation, commission and operation NO ONE is permit to stand under the door and stand in the operating path;

3) While installing and testing the motor package, at least half of the door`s axle MUST be insert into the reducer.

4) Check if there any obstacles in the operating path, if there is please remove the obstacles before lower the gate.

5) DO NOT disassemble the control unit; any damagers due to this action are NOT cover under free warranty.

The company reserves the right to modify the product, according to improvement of technology and production process, while the basic characteristic of the product may remain some.